Santa fe rx set up instructions – Therma-Stor Products Group Santa-Fe Rx Free-Standing Dehumidification User Manual
Page 10

Before operating this unit, please read the Installers & Owners
Manual.
How to prepare the Santa Fe Rx for operation
1. Locate the unit per the manual.
2. Cut the cable tie holding the cord and hose on top.
3. Route the hose to a drain (see manual).
4. Dehumidistat is preset at the factory. See manual for adjustment
instructions.
5. Blower switch is set in the off position at the factory. See manual
for blower operation options.
6. Install the filter (as shown in Figure). Air flow arrow must point
down.
7. Lower the top down so the keyhole slots in the top drop over the
posts. Slide the top until the catch latches to the strike (as shown
in Figure).
SANTA FE Rx SET UP INSTRUCTIONS
10
Santa Fe Rx Installer’s & Owner’s Manual
in first under nuts,
Put this filter side
then push other
side down
Catch
Keyholes
Posts
Strike
Filter