Redial / call waiting / volume setting, Basic operation, Redial out of range – Toshiba FT-8901 User Manual
Page 16: Call waiting, Handset earpiece volume setting, Handset ringer volume setting, Basics

16
BASIC OPERATION
REDIAL
OUT OF RANGE
During a call, as you begin to move too far from the base unit, the
noise increases. Then, you should move close to the base unit. If you
travel out-of-range, your call terminates.(See page 17 “Interference or
static”)
CALL WAITING
To use this feature, you must subscribe to the Call Waiting Service.
1
When you hear a call-waiting tone during your conversation on the
phone, simply press
.
2
To return to the first caller, press
again.
NOTE:
Pressing
without receiving a Call Waiting signal may disconnect the
current caller.
HANDSET EARPIECE VOLUME SETTING
To adjust the earpiece volume, press
during a call.
HANDSET RINGER VOLUME SETTING
To adjust the ringer volume, press
during standby mode.
NOTE:
When the handset is on the base, the handset ringer volume is disabled.
VOL/RING
VOL/RING
FLASH
FLASH
FLASH
Basics
Handset On The Base
1) Pick up the handset and press
.
2) Listen for the dial tone.
3) Press
.
RDL/P
TALK
Handset Off The Base
1) Press
.
2) Listen for the dial tone.
3) Press
.
RDL/P
TALK
FT-8901.qx 1/5/1 11:28 AM Page 16