Topcom Twintalker 1400 - Manual (Page 6)

6 TOPCOM TWINTALKER 1400
TOPCOM TWINTALKER 1400
11.4 TRANSMITTING A SIGNAL
• Press and hold the - button to TRANSMIT. The TX Frame is displayed.
• Hold the unit in a vertical position with the MICROPHONE 10cm from the mouth and speak
into the microphone.
• Release the - button when you want to stop transmitting.
11.5 CHANGING CHANNELS
• Press the - button once, the current channel number flashes on the display.
• Press the - button or the - button to change the channel.
• Press the - button to select the desired channel and return to stand-by mode.
11.6 CALL TONES
A call tone alerts others that you want to start transmitting.
• Press the - button briefly. The call tone will be transmitted for 2 seconds on the set
channel.
11.7 CHANNEL SCAN
CHANNEL SCAN performs searches for active signals in an endless loop from channel 1 to 8.
11.7.1 Activate channel scan
• Press the - button 2 times.
• Press the - button or the - button, until ‘Y’ is displayed, to activate scanning.
• Press the - button to confirm your selection.
• When activity on one of the 8 channels is detected the channel scan will stop and you can lis-
ten to the conversation on this channel.
• Press the - button or the - button to skip the channel.
• If no button is pressed and no activity has been detected, the channel scan will continue
automatically after 5 seconds.
11.7.2 De-active channel scan
• Press the - button 2 times.
• Press the - button or the - button, until ‘-’ is displayed, to de-activate scanning.
• Press the - button to confirm your selection.
11.8 CHANNEL MONITOR .
11.8.1 Activate monitor mode
• Press the - button 3 times to start monitoring the channel activity, The set channel is dis-
played.
• Press the - button to increase or the - button to decrease the speaker volume level.
• Channel monitor automatically stops after 5 seconds
PTT
PTT
PTT
PTT
PTT
Display
You can not change the speaker volume in channel scan mode.
In order for other people to receive your transmission, they must also
be on the same channel.
To check the channel activity use the monitor function (§ 11.8). The
maximum transmitting time is limited to 1 minute. Release and the
press
- button to restart transmitting.
PTT