Toshiba SD-W1101 - Manual (Page 5)

5
Audio Cable (optional) - If you have a sound card and speakers, and
would like to play audio CDs on your computer, you will need to get a
sound cable. Contact AMC, our small parts supplier, at 888/262-9700.
Sound cables are made for the sound card you are using and the DVD-
RAM to which you are connecting. Make sure you have this information
when purchasing a sound cable. The sound cable connects to your sound
card at one end and the other end connects to the digital audio connector
at the left rear of the DVD-RAM
(see DVD-RAM Back Panel photo
on page 6 for location). Refer to
the instructions which came with
your sound card for details on any
sound-driver software required.
Also refer to the REALmagic Hol-
lywood+ User’s guide for addi-
tional audio connection options.
COMPLETING INSTALLATION
After you have connected all the necessary cables, push the DVD-RAM
completely into the computer’s drive slot. Mount drive according to
your computer’s instructions. The screw length should not exceed
3±0.5mm (measured from outside surface of side or bottom of DVD-RAM
to tip of screw). Replace computer cover and all outer screws.
Software Driver: A DVD-RAM software driver must be installed in your
system for your computer to recognize the DVD-RAM drive. You may
also be required to install software that was provided with your DVD/
MPEG card.
I
NSTALLING
DVD-RAM S
OFTWARE
“W
RITE
DVD” (
INCLUDED
IN KIT )
1. Insert “Write DVD” diskette into your A: drive.
2. Go to Start/Run and type A:\setup.exe and press OK.
3. Software driver will be installed.
4. Reboot your system.
,
,
,
,
,
2.5 - 3.5mm
Surface of side or bottom
of DVD-RAM drive
Mounting frame of
host computer
Mounting Screw
M3
1101kit.p65 2/10/99, 3:47 PM 5