1 planning 3 – installation – Tripp Lite SmartRack SRCABLELADDER User Manual
Page 3
3
SRCABLELADDER can provide enclosure-to-enclosure cable routing across an aisle or within a single row. You can combine multiple
SRCABLELADDER and SRCABLETRAY accessories to meet the cable routing needs of almost any configuration of SmartRack Enclosures,
but planning and measurement are required to ensure a secure fit. Tripp Lite recommends that you read the entire manual in advance to gain a
clear understanding of the installation process and accessory positioning.
Sample Cable Routing Configuration (Top View)
Use a tape measure to determine the distance that SRCABLELADDER will bridge. (Preassembling the ladder sections will allow you to observe
their attachment points in place for a more accurate measurement.)
The standard length of SRCABLELADDER is 10 feet. If the standard length and the distance between attachment points differ, adjusting the
position of the SRCABLETRAY accessories will allow you to change the distance between attachment points. If necessary, you can use a single
ladder section instead of two sections, reducing the overall ladder length to approximately 5 feet. In addition, the assembly brackets at the ends
of the ladder sections will allow minor adjustments if you install them without pins, and you can add a few inches to the length of the ladder
by using the alternate pin holes for assembly. If the available adjustments will not accommodate the SRCABLELADDER accessory, you must
cut one of the ladder sections. See Section 3-2 Ladder Modification for instructions. If the SRCABLELADDER accessory will fit without
modification, proceed to Section 3-3 Ladder Assembly.
Note: Prior to installation, you must install the SRCABLETRAY accessory (sold separately) on each enclosure that will be linked by the
SRCABLELADDER accessory. For ordering information, call Tripp Lite Customer Service at +1.773.869.1234.
3-1 Planning
3 – Installation
SRCABLETRAY
SRCABLETRAY
SRCABLETRAY
SRCABLELADDER installed
between enclosures across an aisle.
SRCABLELADDER installed
between enclosures within a row.