Toshiba 27A50 - Manual (Page 18)

18
Set up
Preparation
Basic Operation
Advanced Operation
Reference Section
Watching TV Programs or Video input
TV/VIDEO
CHANNEL t/s
TV
CABLE
VCR
MENU/
ENTER
CH RTN
RECALL MUTE
CH
CH
VOL VOL
1
4
7
2
5
8
3
6
9
0 ENT 100
POWER
o
REW PAUSE FF
SOURCE STILL PIP
SLOW
PIP CH LOCATE SWAP
STOP PLAY REC TV/VCR
TV/VIDEO FAV CH
A
EXIT
Channel
Number
CHANNEL
s/t
TV/VIDEO
T/S t/s
Selecting the TV channels
Select a channel in one of the following two ways.
●
To scan the memorized channels in numerical sequence
Press CHANNEL s to select the next higher channel.
Press CHANNEL t to select the next lower channel.
Press the button again to select the next memorized channels.
● To select a channel directly
Press the Channel Number buttons (0-9 and 100).
To select channel 4, press “4” (or press “0”, “4”).
To select channel 38, press “3”, “8”.
To select channel 125, press “100”, “2”, “5” in sequence.
If you cannot select certain channels, either TV (off the air) or CA-
BLE channels
Check if the TV/CABLE function is properly set. See page 16.
Selecting the video input source
You can use the TV/VIDEO button to view signal coming from other devices,
such as VCR's or video disc players that may be connected to your TV. (See
“Connecting Your TV” on page 5.)
Note : To operate your TV and video equipment properly, refer to the instructions
furnished with the video equipment.
1
Turn the TV and the video equipment ON.
2 Press TV/VIDEO on the Remote Control or
on the TV to select “VIDEO 1” or “VIDEO
2”.
The selected source will be displayed in
purple.
TO SELECT PUSH TV/VIDEO
VIDEO1
VIDEO2
TV
EXIT
RECALL
MENU
3 Operate the video equipment normally.
About the Demonstration Mode
When this function is activated, your TV will automatically display a variety
of its on-screen menus and special features. This function is provided for
demonstration purposes only.
1
Press MENU, then s or t until “DEMO”
in the Option menu is displayed in purple.
2
Press T or S to select “START”.
The on-screen demonstration will start after
about 15 seconds.
To stop the demonstration
Press EXIT or RECALL on the Remote or select “STOP” in the menu.
LANGUAGE:[ENGLISH]FRANCAIS
DEMO:
C.CAPT:
ESPANOL
[START]STOP
C1 C2 C3 C4 T1
T2 T3 T4[OFF]
MOVE[t s] SELECT[T S]
MENU TV / VIDEO VOLUME CHANNEL
POWER
Basic Operation