Telex FIREFLY P350 User Manual
Page 12
The following describes the steps needed to connect the P350.
1.
Turn off all equipment.
2.
Slide the locking mechanism (Figure 6) to release, then lift the P350
to its raised position.
3.
Plug the Firefly™ P350 into an AC wall outlet (the
POWER
button
will glow and one of the cooling fans will be turned on).
4.
Audio input can be amplified by the P350 and heard over the built-in
speakers. Connect a stereo or mono audio source, such as the
auxiliary output of an amplifier, a wireless microphone system, CD
player, tape player, VCR or LaserDisc to the
AUDIO IN
jack (use one
of the two audio cables shown in Figure 4).
5.
If desired, connect an external amplified, mono or stereo
speaker
system to the
AUDIO OUT
jack on the P350.
NOTE: When a cable is plugged into the
AUDIO OUT
jack, the built-in
speakers are disabled.
☞
®
firefly
To Open, Slide
Press Button
to Close
Figure 6. Open and Close the Firefly
™
P350
User Manual 7