Install oil return hose, Install wiring harness – TOYOTA pmn User Manual

Page 57

15. INSTALL OIL RETURN HOSE.

(a) Install the oil return hose onto the oil return pipe and

oil pan adapter using 2 clamps.
K: Clamp (2 pcs.) (14-6)
K: Oil return hose (14-5)

16. INSTALL WIRING HARNESS.

(a) Insert the 15A fuse into the wiring harnesss fuse-

socket.
K: 15A Fuse (23-6)

(b) Insert the vacuum hose into the grommet. Ensure that

that 200mm of vacuum hose and wiring harness
length is in the interior compartment.
K: Vacuum hose (25-1)

hole. (Short end towards interior)
K: Wiring harness No. 2 (23-2)

(d) Install the cable tie wraps into the body holes.

K: Tie wraps (2 pcs.) (23-9)

(e) Route the harness branch with the eyelet towards the

positive battery terminal following the original vehicle
harness using the tie wraps.
K: Tie wraps (5 pcs.) (23-8)

(f) Route the other harness branch together with the

vacuum hose through the tie wraps.

(g) Tighten the tie wraps.
(h) Connect the vacuum hose to the vacuum T-junction.

(i) Route the wiring harness alongside the engine

harness and fix the harness with the original harness
clamps.

200mm