Topfield TF 5100 CI - Manual (Page 35)

4.1 Searching broadcasting services 29
the 2(E) movement option, the antenna will move to the
east by two degrees. At this time you had better check
the receiving quality of every transponder and choose
the best one at the Transponder (or Frequency) option.
It will be helpful to your fine tuning.
5. Finally select the Store option at the Motor Control menu
to save the tuned position when the receiving quality
has turned good.
There are more motor control options for installers, but this
manual does not describe them. If you are an installer, refer
them to the manual for the STAB rotor.
4.1.3 Configuring USALS settings
USALS (Universal Satellite Automatic Location System), also
known as DiSEqC 1.3, calculates the positions of all available
satellites from your location. Compared to DiSEqC 1.2, it is
no longer required to manually search and store every satel-
lite position. Just by pointing to a known satellite position is
enough. This position will act as the central point. The USALS
will then calculate positions of visible satellites.
To use USALS, select the Instal-
lation > USALS Setting
menu.
At first you have to set the Mo-
torized DiSEqC 1.3
option to
Enable .
To calculate every satellite position, perform the following steps: