beautypg.com

Tatung TCM-1901 User Manual

Page 4

background image

2

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications.

However, there is no guarantee that interference will not occur in a particular installation.

If his equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Shielded interface cables and A.C. power cord, if any, must be used in order to comply

with emission limits.

Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

SAFETY PRECAUTIONS

1. Operate this unit only from the type of power source indicated on the label.

2. Do not block or cover ventilation openings on the back or bottom of the monitor cabinet.

3. Do not place this monitor near a radiator or heating vent.

4. Do not push objects of any kind through cabinet openings. This may result in fire or

electrical shock.

5. Before adding attachments always ask a service technician to perform routine safety

tests to determine that equipment is in safe operating condition. Ground potential tests

should be part of the routine safety check made by the service technician.

6. Do not place monitor on an unstable cart, stand, or shelf where it may fall and injure

personnel or damage equipment.

This manual is related to the following products: