TechniSat EC 4004 - Manual (Page 17)

TechniSat EC 4004
17
5 Programmation
5.1 Preprogrammed channel tables
The receiver is preprogrammed for the reception of 396 television and radio channels. The
channels are listed on
4 tables which can be found in chapter 6.2.
Table 1: channels from ASTRA 1A, 1B, 1C and 1D: Unysat LNB LOF 9.75 GHz
Table 2: channels from ASTRA 1A, 1B, 1C: LOF 10.0 GHz
Table 3: channels from different satellites for CombySat LNB
Table 4: channels from different satellites for Tripleband LNB
Additionally, there is a user table which you can use to customize your channel collection. This
table is identified with "F" on the display. For a device in factory configuration, this corresponds
to table 1.
You can select individual channels from a table without modifying the user table.
> to call a preprogrammed table
SAT
> press and then press
> until you reach the desired table
> finally enter the desired channel number.
You have just selected channel 15 from table 2 without memorizing it. Take into account that
a picture is only displayed if your receiving equipment is appropriate for the channel.
MEM
> select • and then the channel position number to
> memorize this channel in the user table.
> to load and memorize a preprogrammed table
SAT
> press quickly followed by
> until you reach the desired table.
.
> Then immediately press the recessed MEM key using a ball point pen and the
> desired table is memorized as user table.
5.2 Individual channel table
5.2.1 Channel order
Example: You want to change the order of the first two channels, ARD and ZDF.
> select channel 1, ARD.
*EC 4004 ENGL. 14.12.1999 9:59 Uhr Seite 17