Perreaux SX60m - Manual (Page 12)

ne input specifications, please refer to
hapter 11.
For more information on li
C
Please refer to the operating manual of your preamplifier
to verify that the pin assignments of the balanced output
connectors
Note:
correspond to the SX60m balanced inputs. In
the event that they are not compatible, the
interconnecting cable will need to be altered to suit.
Balanced Output
Balanced Output to other amplifiers (e.g. bi-amping), accepts a
standard balanced connector (XLR).
Pin 3: Signal – (inverting)
Shield ground: Chassis ground
For m fications, please refer
to Chapter 11.
Th e balanced XLR output connectors are
as follows:
Pin 1: Signal ground
e pin assignments of th
Pin 2: Signal + (non-inverting)
ore information on line output speci
Please refer to the operating manual of your amplifier to
verify that the pin assignments of the balanced input
connectors co
Note:
rrespond to the SX60m balanced outputs. In
the event that they are not compatible, the
interconnecting cable will need to be altered to suit.
Speaker Binding Posts
Binding posts are clearly marked and colour coded RED Positive
(+) and BLACK Negative (-). This polarity must be observed
s, i.e. positive terminal of the when connecting loudspeaker
SX60m to the positive terminal of the loudspeaker and negative
terminal of the SX60m to the negative terminal of the
loudspeaker.
Never connect either of the output terminals to ground.
Never connect the amplifier’s output terminals to any
device other than a loudspeaker.
. Please do not short-circuit the amplifier’s output terminals
Never connect the output of one amplifier to the output
terminals of another amplifier.
Do not over-tighten the binding posts on your amplifier.
Caution!
11