Transcend Information 128 - Manual (Page 14)

11
Record LED turns red.
5. Press the REC button. The Record LED blinks red and voice recording starts.
6. Press the REC button to stop voice recording when you wish to stop.
7. Press the REC button to start voice recording when you wish to start again.
™ The recorded files (VXXX.WAV format) are saved on the folder “Voice”, in an ascending
order.
™ With sufficient power: 128MB memory can store up to 9 hours of recorded voice.
256MB memory can store up to 18 hours of recorded voice.
™ To achieve better quality recording, keep JetFlash and the voice source within 7 meters
distance.
™ If JetFlash is full and there is no memory available for voice recording, the Power/PLAY LED
turns on. To make memory available for voice recording, delete some files or folders from
JetFlash.
™ To resume MP3 mode, press and hold PLAY/PAUSE button until the Record LED
turns off.
To Play the Recorded Files
1. Disconnect JetFlash from your computer.
2. Set HOLD switch to “OFF” position.
3. Press and hold the PLAY/PAUSE button for a few seconds to power on (enter MP3
mode). The Power/Play LED turns green.
4. Press and hold the REC button for a few seconds to enter Record mode. The
Record LED turns red.
5. Press the PLAY/PAUSE button to play the recorded files. The Power/Play LED
blinks green.
™ To resume MP3 mode, press and hold PLAY/PAUSE button until the Record LED
turns off.
™ To power off, press and hold the PLAY/PAUSE button until the Power/Play LED
turns off.
™ For more operating instructions, please refer to Basic Operation.