Transcend Information 128 - Manual (Page 13)

10
To Play MP3 Music
1. Make sure you have downloaded MP3 or WMA files to the root directory of your JetFlash.
2. Disconnect
JetFlash from your computer.
3. Connect the earphone with the earphone jack .
4. Set HOLD switch to “OFF” position.
5. Press and hold the PLAY/PAUSE button for a few seconds to power on (enter MP3
mode). The Power/Play LED turns green.
6. Press the PLAY/PAUSE button again. The Power/Play LED blinks green and the
MP3/WMA files are played back, in alphabetical order.
7. To pause music playback, press PLAY/PAUSE button.
8. To power off, press and hold the PLAY/PAUSE button until the Power/Play LED
turns off.
™ For more operating instructions, please refer to Basic Operation.
AB Repeat Function
Following the procedures below, you can repeat a portion of one track. Make sure the HOLD
switch is set to “OFF”.
1. Enter MP3 mode and play the tracks.
2. Press the Volume Control Wheel to tag the beginning of the portion you wish to
repeat. The Repeat LED blinks orange at fast speed, and music playback continues.
3. Press the Volume Control Wheel again to tag the end of the portion you wish to
repeat. The Repeat LED blinks orange at slow speed, and the tagged portion is played as a
continuous loop.
4. To resume normal playback, press the Volume Control Wheel .
™ For more operating instructions, please refer to Basic Operation.
Voice Recording Function
To Record Voice
1. Disconnect JetFlash from your computer.
2. Set HOLD switch to “OFF” position.
3. Press and hold the PLAY/PAUSE button for a few seconds to power on (enter MP3
mode). The Power/Play LED turns green.
4. Press and hold the REC button for a few seconds to enter Record mode. The