Toshiba 27AF62 - Manual (Page 17)

W
elcome to Toshiba
Connecting
y
our T
V
Using the
Remote Contr
ol
Setting up
y
our T
V
Using the T
V’s
F
eatur
es
Appendix
17
Selecting the signal source
To select the signal source to view:
1. Press TV/VIDEO on the remote control or the TV.
2. Use the CHANNEL NUMBERS on the remote control to select
the number (0–5) that corresponds with the desired source.
(You can also repeatedly press the TV/VIDEO button on either the
remote control or the TV to cycle through the sources.)
0–5: TO SELECT
SOURCE SELECTION
0: ANT 1
1: VIDEO 1
2: VIDEO 2
3: VIDEO 3
4: ColorStream
5: ANT 2
To display the current signal source:
Press TV/VIDEO or RECALL. The current source displays in
purple.
Programming channels into the TV’s memory
When you press CHANNEL ▲▼ on the TV or remote control,
the TV stops only on the channels stored in the TV’s memory.
Note: To tune the TV to a channel not programmed into the memory,
use the CHANNEL NUMBERS on the remote control.
Follow the steps below and on the next page to program channels into
the TV’s memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and
store them in the TV’s memory. After the channels are stored auto-
matically, you can manually add or erase individual channels (see
page 18).
If you use both ANT-1 and ANT-2 terminals, you will need to
program channels for each signal source.
To program channels automatically:
1. Press MENU.
2. Press
x or • to highlight the SET UP menu.
3. Press y or z to highlight TV/CABLE.
4. Press x or • to highlight TV (if you use an antenna) or CABLE (if
you use cable).
5. Press z to highlight CH PROGRAM.
MOVE SELECT [ ] [ ]
LANGUAGE:
ANT1/2:
TV/CABLE:
CH PROGRAM
ADD/ERASE:
MORE
[ENGLISH] FRANCAIS ESPANOL
[ANT1] ANT2
[TV] CABLE
[ADD] ERASE
SET UP
MOVE SELECT [ ] [ ]
LANGUAGE:
ANT1/2:
TV/CABLE:
CH PROGRAM
ADD/ERASE:
MORE
[ENGLISH] FRANCAIS ESPANOL
[ANT1] ANT2
[TV] CABLE
[ADD] ERASE
SET UP
6. Press x or • to start automatic channel programming (“CH
PROGRAM” displays on-screen). The TV automatically cycles
through every TV or cable channel (depending on which you
selected), and stores all active channels in the TV’s memory.
7. When automatic channel programming is complete, the message
“CH Programming Completed” appears.
8. Press CHANNEL ▲▼ to view the programmed channels.
DEMO MENU TV/VIDEO VOLUME CHANNEL
TV Front Panel
TV/VIDEO
CH RTN
ADV/
PIP CH
ADV/
PIP CH
LIGHT
MUTE TV/VIDEO TIMER
RECALL POWER
TV
CABLE
VCR
ENT
ENTER
PLAY PIP
REC
STILL LOCATE SWAP
TV/VCR REW FF
STOP SOURCE
FAV FAV
C.
CAPT
EXIT
MENU
RESET
1
4
2
5
3
6
7 8 9
0 100
Channel
Numbers
MENU
CH CH (Channel)
VOL
CT-9946
RECALL
TV/VIDEO