True Manufacturing Company Freezer / Refridgerator Swing Door T-23DT - Manual (Page 8)

............ www.truemfg.com ............
True Food Service Equipment, Inc.
6 6
INSTALLATION / OPERATION INSTRUCTIONS
Rail End
Lower Rail
Assembly
Snug Fit
Here
Leveling Shim
Castor Leg
Bearing
Race
Lower Rail Assembly
Snug Fit
Here
Rail End
Thread castor into the underside of
cabinet frame rail. Thread leg into cabinet bottom
frame rail.
The end of the leg is adjustable
to easy leveling.
Use the tool provided to tighten
the castor into place. For leveling, insert the shim
between the castor and frame rail.
1 2 3 4
5
INSTALLATION OF CASTORS OR OPTIONAL LEGS
Important Safeguard for installation of leg/castor (Images 1-5 demonstrate procedure)
Securing Castors and Legs
To obtain maximum strength and stability of the unit,
it is important that you make sure each castor is secure.
Optional legs are hand-tightened securely against the
lower rail assembly see image 4-5. The bearing race on
the castor or the top edge of the leg must make firm
contact with the rail.
Unit leveling
Four leveling shims have been provided for leveling
castored units positioned on uneven floors. Shims must
be positioned between rail end and bearing race.
A. Turn the bearing race counter-clockwise until the
cabinet is level. Level front to back and side to side.
(diagonally)
B. Install the desired number of shims, making sure the
slot of the shim is in contact with the threaded stem
of the castor. (See image 2)
C. If more than one shim is used, turn the slot at a 90°
angle so they are not in line.
D. Turn the bearing race clockwise to tighten and secure
the castor by tightening the anchoring bolt with a
3/4 inch open-end wrench or the tool provided.
(See image 3)
CAUTION
To avoid damage to lower rail assembly, slowly raise unit to
upright position.
NOTE
Open holes located on the cross members of the frame rail
should be plugged before unit is in use.