Tanita BF-572 - Manual (Page 6)

Important Features of the BF-572
• The BF-572 allows you to measure both weight and body fat per-
centage simultaneously as easily as stepping on a scale.
• The BF-572 stores results over time and displays them graphically
so that users can track their progress.
• The BF-572 can be set for a Adult, Athlete or Child, Female or
Male, increasing the accuracy of the reading.
• Personal data (Adult/Athlete/Child, Female/Male and Height)
can be stored in the memory of the unit for up to four people.
• Weight-Only Key provides quick weight readings.
• The unit emits a helpful “beep” when activated, and also at
various stages in the programming and measuring processes.
Listen for these sounds which will prompt you to step on the
unit, look at your reading(s), or confirm a setting.
Selecting the Weight Mode (lb, kg or st-lb)
The BF-572 can measure weight in three different modes: lb (pounds),
kg (kilograms) or st-lb (British stone-pounds). The default setting (the
setting at which Tanita products are shipped) is lb. If you would like
to change that setting, or if at any point another setting has been
inadvertently entered, follow these steps:
Press and simultaneously. Release the buttons, the dis-
play will flash all three weight modes at the same time. Press to
cycle through each weight mode until just the mode that you require
is displayed. Then press
. The unit will beep twice in short suc-
cession, and the display screen will flash to confirm your selection
and store it in memory.
Note: If weight mode is set to pounds or stone-pounds, the height
programming mode will be automatically set to feet and inches. Similarly,
if kilograms is selected, height will be automatically set to centimeters.
Automatic Shut-Down Function
The automatic shut-down function shuts off the power
automatically in the following cases:
• If you interrupt the measurement process. The power will shut
down automatically within 10 to 30 seconds, depending upon the
type of operation.
• If an extraordinary weight is applied to the platform.
• If you make a mistake during measurement or a key or
button operation.
• During programming, if you do not touch any of the keys or but-
tons within 60 seconds.
• After you have completed the measuring process.
Preparations Before Use
Inserting the Batteries
Locate the battery cover on the back of the measuring platform.
Press the tab to release the cover as shown and insert the supplied
AA-size batteries as indicated.
Note: Be sure that the polarity of the batteries is set properly. If the
batteries are incorrectly positioned, the fluid may leak and damage
floors. If you do not intend to use this unit for a long period of time,
it is advisable to remove the batteries before storage.
Positioning the Unit
To ensure safe and accurate measurement, place the unit on a hard,
flat surface where there is minimal vibration.
Note: To avoid possible injury, do not step on the edge of
the platform.
Attaching the Support Feet
If (and only if) you would like to place the unit on carpet, insert
the supplied support feet into the holes at the four corners on
the bottom of the measuring platform.
Note: Do not use the unit on any carpeting that is more than 0.8” (20 mm)
in thickness.
Do not use the support feet on hard, flat surfaces, as the
unit may tip over.
4
Open as shown.
Direction of the batteries.