Texas Instruments THS3001 - Manual (Page 8)

Features
1-2 General Information
1.1 Features
THS3001 operational amplifier EVM features include:
J High Bandwidth — 340 MHz, – 3 dB at
±
15 V
CC
& Gain = 2
J ±
5-V to
±
15-V Operation
J Inverting and Noninverting Single-Ended Inputs
J Module Gain Set to + 2 (Noninverting) and –1 (Inverting) — Adjustable
Through Component Change.
J Nominal 50-
Ω
Impedance Inputs and Outputs
J Standard SMA Miniature RF Connectors
J Good Example of High-Speed Amplifier Design and Layout
1.2 Description
The TI THS3001 high-speed current-feedback operational amplifier
evaluation module (EVM) is a complete high-speed amplifier circuit. It consists
of the TI THS3001 high-speed current-feedback operational amplifier IC,
along with a small number of passive parts, mounted on a small circuit board
measuring approximately 1.7 inch by 1.4 inch. The EVM uses standard SMA
miniature RF connectors for inputs and outputs and is completely assembled,
fully tested, and ready to use — just connect it to power, a signal source, and
a load (if desired).
Two versions of the THS3001 EVM are available. The original appears in
Figure 1–1 and the Rev. A version appears in Figure 1–2.
Figure 1–1. THS3001 Evaluation Module – Original Version
NONINVERTING
+ +
R1
R4
+VCC
C3
R5
C2
C1
GND
–VCC
R2
C4 R3
U1
J3
–IN
GND
J2
J1
+IN
GND
INVERTING
LITERATURE NO
SLOP 130
009957 THS3001 EVM
OUT GND