Topcom DIABLO 150 User Manual

Page 7

Topcom Diablo 150/Twin/Triple/Quattro

ENGLIS

6.3

Calling a number from the Call list

Scroll through the Call list until the desired number is shown on the display.

Press the Off-hook

button

. The number will be dialled automatically.

6.4

Erasing one or all number from the Call list

Scroll through the Call list until the desired number is shown on the display.

Press the Mute button

short to erase the current entry or press and hold the Mute button

for 3 sec. to erase the compleet

call list.

6.5

Store a number from the call log into the memory

Scroll through the Call list until the desired number is shown on the display.

Press and program

button

for 3 sec.

The memory will be shown and you can scroll through it with the scroll keys

to see which entry is still empty (0-9)

Enter the memory location (0-9) where you want to store

the number.

Edit the number if needed and press the program button

again to confirm and to go

back to standby.

Register a handset

7.1

Register to a Topcom Diablo base

You can subscribe 5 handsets to one base unit. By default, each handset is subscribed on the base unit
upon delivery.
You only need to subscribe the handset if:
•

The handset subscription has been removed from the base unit (e.g. for reinitialisation)

•

You want to subscribe a different handset to this base unit.

The below procedure is only applicable to a Topcom Diablo handset and base unit!!
Keep the Paging key on the base unit pressed for 10 seconds until the Line/Charge indicator
on the base unit begins to blink rapidly. The Line/Charge indicator

will blink rapidly for one minute.

During this minute, the base unit is in register mode and you must do the following to subscribe the
handset:
Press and hold the Program

key for 6 sec until there is a ‘-’ scrolling on the screen from left to right.

The handset is now searching for the base. When a base is found the handset will ask to enter the pin-
code ‘P1-_’. Enter the base pin code (0000). If the pin is wrong, the handset will restart the searching for
the base.

When the handset is registered, it will show the handset number followed by the time.

Call transfer and Intercom between two handsets

8.1

Call transfer and conference call during an external call

During an external call, press and hold the INT key until INT appears . Press the number (1-5) of the
other handset.

The other handset will start to ring:

–

When the other handset takes the line you can talk internally.
If you hang up, the external line will be connected with the other handset.
If you press the ‘#’-key you can talk with the 2nd handset and external line at the same time
(conference call)

–

Or press and hold the INT key again to return to the external call.

Press the On-hook button

to end the call.

These functions only work when more then one handset (like a Twin/Triple/Quattro
version) is registered to the base!