Toshiba SG-1800 - Manual (Page 17)

17
Preparation
CARRYING THE HANDSET IN THE BELT CLIP
You can attach the Belt Clip to the handset in order to carry it on your belt.
Attaching the Belt Clip to the Handset
Insert the Belt Clip tabs into the holes
on each side of the handset until they
click.
NOTE:
Be sure to insert the tabs properly into each
hole to prevent the Belt Clip from falling off.
Removing the Belt Clip from the Handset
Pull both sides of the Belt Clip to release the tabs from the grooves.
NOTE:
Remove the Belt Clip carefully from the handset, taking care not to hurt your
fingers or damage your nails.
USING A HEADSET
You can talk with hands-free convenience using an optional headset
(part#: RC 008260) that has a 3/32-inch(2.5mm) plug.
To connect the headset, open the
rubber cover on the left side of the
handset, then insert the headset's plug
into the jack.
With a headset connected, you can
make or answer calls as usual using
the keys on the handset.
You can use the supplied Belt Clip to
hang the handset on your belt for
greater convenience.
When you finish using the headset,
disconnect it from the handset and
close the rubber cover to protect the
jack.
NOTES:
• The handset's earspeaker and microphone are turned off with a headset
connected.
• Pressing the (
▲,▼) button of the handset also controls the connected
headset's volume.
• If you place the handset on the base unit while the headset is connected, be
sure the handset is placed properly.
VOL
INSTALLATION
*SG-1800.qx 7/11/0 7:03 PM Page 17