Technicolor - Thomson 27LB120S4 - Manual (Page 3)

3
20.Stand—Do not place the product on an unstable trolley,
stand, tripod or table. Placing the product on an unstable base
can cause the product to fall, resulting in serious personal
injuries as well as damage to the product. Use only a trolley,
stand, tripod, and bracket or table recommended by the
manufacturer or sold with the product. When mounting the
product on a wall, be sure to follow the manufacturer’s
instructions.
Use only the mounting hardware recommended by the
manufacturer.
21.Careful move— When relocating the product placed on a
trolley, it must be moved with the utmost care. Sudden stops,
excessive force and uneven floor surfaces can cause the product
to fall from the trolley.
22.Panel protection—The LCD panel used in this product is
made of glass.
Therefore, it can break when the product is dropped or
impacted upon by other objects. Be careful not to be injured by
broken glass pieces in case the LCD panel breaks.
23.Pixel defect—The LCD panel is a very high technology product, giving you finely detailed pictures.
Occasionally, a few non-active pixels may appear on the screen as a fixed point of blue, green or red.
Please note that this does not affect the performance of your product.
For added protection for this television equipment during a
lightning storm, or when it is left unattended and unused for lon
g
periods of time, unplug it from the wall outlet and disconnect
the antenna. This will prevent damage to the equipment due to
lightning and power-line surges.
An outside antenna system should not be located in the vicinity
of overhead power lines or other electric light or power circuits,
or where it can collide with such power lines or circuits. When
installing an outside antenna system, extreme care should be
taken to keep from touching such power lines or circuits, as
contact with them might be fatal.
On some models, the screen is protected by a glass shield.
Under certain conditions (changes of temperature and humidity)
moisture may form between the glass and the screen.
If this relatively rare condition arises, it is only necessary to
switch on the LCD TV, to make it disappear progressively.