Technicolor - Thomson VMD 6 - Manual (Page 32)

E N
3 1
PLAYBACK Basic Playback For Video
PL
AY
OFF
Power Switch
Rewind Button (2)
Fast-Forward Button
(3)
Play/Pause Button
(4/6)
Stop Button (5)
1 Load a tape (
੬
pg. 10).
2 Set the VIDEO/DSC Switch to “VIDEO”, then set the
Power Switch to “
” while pressing down the
Lock Button located on the switch. To start playback,
press 4/6.
•To stop playback, press 5.
•Press 2 to rewind, or 3 to fast-forward the tape
during Stop mode.
To Control The Speaker Volume . . .
.... slide the Power Zoom Lever (VOL.) towards “+” to turn
up the volume, or towards “–” to turn down the volume.
NOTES:
● If Stop mode continues for 5 minutes when power is
supplied from a battery, the camcorder shuts off
automatically. To turn on again, set the Power Switch to
“OFF”, then to “
”.
● The playback picture can be viewed in the LCD monitor,
viewfinder or on a connected TV (
੬
pg. 40).
● You can also view the playback picture on the LCD
monitor with it flipped over and pushed against the
camera body.
● LCD monitor/viewfinder indications:
• When power is supplied from a battery: the “ ”
battery pack remaining power indicator is displayed.
When power is supplied through the DC cord: “
”
does not appear.
• During Stop mode, none of the indications are
displayed.
● When a cable is connected to the AV connector, the
sound is not heard from the speaker.
Power Zoom
Lever (VOL.)
Speaker
Lock Button
Still Playback: Pauses during playback.
1) Press 4/6 during playback.
2) To resume normal playback, press 4/6 again.
● If still playback continues for more than about 3 minutes, the camcorder’s Stop mode is automatically
engaged. After 5 minutes in the Stop mode, the camcorder’s power is automatically turned off.
● When 4 /6 is pressed, the image may not pause immediately while the camcorder stabilises the still
image.
Shuttle Search: Allows high-speed search in either direction.
1) Press 3 for forward or 2 for reverse search during playback.
2) To resume normal playback, press 4/6.
● During playback, press and hold 2 or 3 . The search continues as long as you hold the button.
Once you release it, normal playback resumes.
● A slight mosaic effect appears on screen during Shuttle Search. This is not a malfunction.
Frame-By-Frame Playback: Allows frame-by-frame search.
1) Engage Still Playback.
2) Rotate MENU/BRIGHT towards “+” for forward Frame-By-Frame Playback, or towards “–” for reverse
Frame-By-Frame Playback during Still Playback.
Ⅲ To resume normal playback, press 4/6.
● You can also use the provided remote control for Frame-By-Frame Playback (
੬
pg. 50).
Playback Zoom and Playback Special Effects
Available only with the remote control (provided) (
੬
pg. 50, 51).
VIDEO/DSC Switch (Open the
LCD monitor to access this switch)
VMD6 EN(02/39) 28/08/00, 15:49 31