Tech Craft FLEX52W - Manual (Page 12)

INSTALLATION FOR WALL MOUNT OF A MOUNTING FRAME ON A WOODEN FRAME.
IF YOU WANT TO HANG YOUR TV
ON THE WALL, FOLLOW THESE
STEPS.
4x
IHA0547
ø7.6 x 62 mm
12
OPTION 3
DETAIL #2 DETAIL #1
stud sensor
16
inches
IHA0546
IHA0547
1- The mounting frame must be mounted to two studs at least 12” apart. Use a high quality stud sensor to locate
two adjacent studs. It is a good idea to verify where the studs are located with an awl or thin nail shown in
Detail 1.
2- Pre-drill a 2 1/2” deep hole at the desired height in each stud using a 3/16” drill bit. Make sure these holes are
in the center area of the studs and level with each other.
3- Use the mounting frame as a template to mark the location of the second hole in each stud and drill another
set of holes 2 1/2” deep with the 3/16” drill bit in the marked location.
4- Attached the mounting frame to the wall using the four lag bolts (IHA0547) and four washers (IHA0546). Make
sure the horizontal supports are oriented so the flat surface is against the wall and that a set of lag bolts is on
each side of the four small slots as shown in detail #2.
TOOL REQUIRED:
Hammer, Power Drill, 3/16” drill bit, socket or wrench set, stud sensor, awl, level, open wrench
TECHCRAFT highly recommends that you use a qualified professional
contractor to perform the entire installation.
TECHCRAFT is NOT liable for any damages or injury caused by incorrect use of the product including use for
a purpose not specified by TECHRAFT, incorrect mounting, incorrect assembly, incorrect installation, or other
failure to follow the instructions in this manual.
CAUTION:
‡ For installation only on wooden studs or on cinder block walls or concrete walls. The hardware supplied with
this product is only intented for these types of walls. The supplied hardware is NOT designed for metal studs.
! If you are uncertain about the nature of your wall, consult a qualified installation contractor.
‡ Wall must be in conformity with building code. Ensure the wall has the capability to support the appropriate
load bearing.
‡ Do not use this product for any purpose or use not specified by TECHCRAFT.
INSTALLATION WARNING
‡If you do not understand these instructions or have any doubts about the nature or capacity of your walls or any
doubts about the safety of the installation, call a qualified professional contractor or contact Techcraft
Manufacturing Inc. at www.techcraft.net;
‡If the hardware you need is not included, please consult your local hardware store or contact us at
www.techcraft.net
‡ For the optimum viewing height, please consult the owners manual from your television manufacturer.
(TWO) 2 PERSONS ARE REQUIRED FOR
THIS STEP
CAUTION: