beautypg.com

How to replace the stylus, Discs, Discs how to replace the stylus – Teac CD recorder with turntable/cassette player LP-R550USB User Manual

Page 6: Cd cd-r cd-rw

background image

6

Please use CD, CD-R and CD-RW discs bearing the
“DIGITALAUDIO” mark.

CD

CD-R

CD-RW

< Depending on the quality of the disc and/or the condition of the

recording, some CD-R or CD-RW discs may not be playable.

< Copy-protected discs and other discs which do not conform

to the CD standard may not play back correctly with this unit.
If you use such discs with this unit, TEAC Corporation and
its subsidiaries cannot be responsible for any consequences
or guarantee the quality of reproduction. If you experience
any problems with such non-standard discs, contact the disc
manufacturers.

Handling precautions

< Always place the disc on the disc tray with the label side up.

Compact discs can be played or recorded only on one side.

< To remove a disc from its storage case, press down on the center

of the case and lift the disc out, holding it carefully by the edges.

How to remove the disc

How to hold the disc

Discs

How to Replace the Stylus

The stylus should last about 50 hours under normal use.
However, it is recommended that the stylus be replaced as soon as
you notice a change in sound quality.
Prolonged use of a worn-out stylus may damage the record.
Wear and tear on the stylus will be accelerated under frequent use
of 78 RPM records because of its higher speed.

CAUTION:

< Do not disassemble or bend the stylus.

< Handle with care, as the stylus is delicate. Use of a bent or

broken stylus may damage the record and cause the turntable to
malfunction.

< To avoid injury, do not touch the tip of the stylus.
< Keep the stylus out of the reach of children.
< Do not expose the stylus to extreme heat.
< Contact a qualified repair company if you experience difficulty in

replacing the stylus.

Removing old stylus

1. Turn off the unit’s power before you replace the stylus.
2. Set a screwdriver at the tip of the stylus and push it down in the

direction “A”.

3. Remove the stylus by pulling it forward.

A

Installing a new stylus

1. Hold the tip of the stylus and insert the other edge by pressing in

the direction “B”.

2. Push up in the direction “C” until it locks at the tip.

B

C

Replacement stylus (sold separately):
STL-103 (includes 3)
SPL-102 (includes 2, for SP records only)
For stylus replacements, contact your dealer or TEAC listed on the
back of this Owner’s manual.

This manual is related to the following products: