Technicolor - Thomson SCENIUM DPL5000 - Manual (Page 10)

EN
17
Operating your Receiver
Storing radio stations
The receiver can store up to 40 radio stations in
memory. You can enter every single radio station
yourself or the receiver can store all available radio
stations automatically in an ascending order.
Auto Preset Programming (APP) : (FM only)
1. In Tuner mode, select the
FM band by pressing
TUNER on the remote
control.
2. Press and hold the TUNER button on the remote
control for 3 seconds. “MEMORY” will be displayed
in red and will blink during the automatic storing
process.
Radio frequencies will be scanned and radio stations will
be stored automatically. When all available radio
stations are stored or if all 40 memory locations are full,
the auto preset will stop.
Manual preset
1. Select FM or AM band by pressing TUNER repeatedly.
2. Tune to the radio station to be stored. (see "Manual
tuning" on page 16 above for details)
3. Press the SAVE button on
the remote control.
"MEMORY" will flash and
a preset number will be
shown on the display.
4. While MEMORY is still
flashing on the display,
press PR or PR
on the remote control
to select the desired
preset memory location.
5. Press the SAVE button on
the remote control to
store frequency in selected
preset location.
6. Repeat steps 1-5 to store other frequencies.
Retrieving preset stations
1. Press TUNER on the remote control to select tuner
mode.
2. Press the PRESET + or - buttons on the main unit or
the PR or PR buttons on the remote control
to select the preset station.
NOTE
A Weak signal can affect the "Automatic Preset
Storing function" efficiency. Adjust the antenna
for the best reception, and a more efficient
search.
Operating your Receiver
Operating the Radio
The receiver has a built-in tuner that allows for AM/FM
radio function.
Manual tuning
1. Connect the FM and AM antenna accordingly (see
"Connecting the Antenna" on page 5 section for
details)
2. Press ON/ECO on the main unit or on the remote
control to switch on the receiver.
3. Press the SOURCE button repeatedly on the main
unit until the tuner mode is selected or press TUNER
on the remote control.
4. To select between FM
and AM band, press the
TUNER button
repeatedly.
5. Tune to a station by
pressing TUNER - or
TUNER + repeatedly
until the desired station
is found.
Automatic Tuning
Press and hold TUNER - or
TUNER + for about one
second to activate the
automatic SEARCH function.
The receiver will
automatically tune
frequencies until it finds a
station.
Select a sound effect if needed by pressing the
SURROUND button. (see "Advance sound section" for
details).
Selecting Mono or Stereo Sound
Press the ST•MONO button
on the remote control to
toggle between mono and
stereo sound in FM tuner
mode (when available).
NOTE
1. If there is interference, move the location of
the antenna until the optimal sound is heard.
TV and other electronic devices could be the
cause of interferences so try to position the
antenna away from them.
2. Weak signal can affect the "auto Search
function". Adjust the antenna for better
reception and for a more efficient search.
16
ON/ECO
RCE SURROUND PRESET
VOLUME
PHONES
PRESET
VOLUME
PHONES
SUBWOOFER SOURCE SURROUND