Toshiba MD14F52 - Manual (Page 12)

12
Introduction
1 2 3
• Aim the remote control at the remote sensor and press control buttons to operate.
• Operate the remote control within 30° angle on either side of the remote sensor, up to a distance of approx. 5
meters.
Replace the compartment
cover. Install two “R03/AAA” batter-
ies (supplied), paying attention
to the polarity diagram in the
battery compartment. Open the battery compart-
ment cover in the direction of
the arrow.
Caution:
Never throw batteries into a fire.
Notes:
• Be sure to use AAA size batteries.
• Dispose of batteries in a designated disposal area.
• Batteries should always be disposed of with the environment in mind. Always dispose of batteries in accord-
ance with applicable laws and regulations.
• If the remote control does not operate correctly, or if the operating range becomes reduced, replace batteries
with new ones.
• When necessary to replace batteries in the remote control, always replace both batteries with new ones.
• Never mix battery types or use new and used batteries in combination.
• Always remove batteries from remote control if they are dead or if the remote control is not to be used for an
extended period of time. This will prevent battery acid from leaking into the battery compartment.
Inserting batteries
Operation
Approx. 5 meters
Illustration of MD20F52
Identification of controls (Continued)
5W20101A [E] (P08-12) 12/23/05, 14:33 12