Teledyne MX300 - Manual (Page 30)

Operating Instructions MX300
Teledyne Analytical Instruments 22
 Perform alarm test before each use (press the ALARM TEST key).
 Use only isopropyl alcohol or mild detergent, if cleaning is required,
– DON’T –
 Use this Monitor if you suspect any malfunction.
 Use the Monitor in the presence of flammable gases.
 Use anything but alkaline batteries.
 Autoclave or freeze the sensor or Monitor.
 Open or try to repair a leaking or broken sensor.
 Immerse the unit or sensor in any liquid.
 Pass hot or cold gas mixtures over the sensor.
 Expose the unit to devices that produce high levels of radio, short
wave, microwave, x-ray, or high frequency interference.
 Use cleaning agents or liquids in the cable receptacles or around the
battery compartment.
 Place the unit in a water vapor-saturated environment.
 Expose the LCD to excessive sunlight.
 Expose the unit to a condensing water environment such as a mist
tent.