Tesla TI4100 GPU-24 - Manual (Page 33)

Chapter 8
ON/OFF SWITCH
General Information And Operation
7-1. General
The TI4100GPU-24 comes equipped with an On/Off switch on the face
plate, This switch controls AC power input only, It does not control
the DC output power to the aircraft, Whenever the unit is plugged
into an aircraft, it is supplying DC power, The ON/OFF switch located
on the face plate does not have any control on the DC output power
funtion
8-2. OPERATION
1) Place the On/Off switch in the Off position.
2) Plug the unit into 208/240 single phase 30 AMP AC power.
3) Connect the DC cord to the Aircraft or vehicle. ( At this time the
unit will be providing 24 VDC Power)
4) Place the On/Off switch to the on position. After 2-3 seconds, The
led bar graph should light and the fans should begin to operate.
5) If the fans and led bar graph do not operate, than check the AC
outlet for power.
NOTE
The power cells will only recharge while the On/Off
switch is in the on position. The On/Off switch does
not control the DC output power.
8-1