Toshiba W-704C - Manual (Page 39)

3 9
RECORDING
VCR display
6
Select “CONTROL” using PLAY/x2 or STOP , and set to “ON”
or “OFF” using FF or REW .
ON: if your DSS ® satellite receiver is
remote-controllable.
• Satellite channels will be selected by
CH (CABLE BOX) on the remote
control.
The VCR can change the satellite
channel to the desired one when timer
recording starts.
→
Go to step 7.
OFF: if your DSS ® satellite receiver is
NON remote-controllable.
• Satellite channels will be selected by
the own channel selector of the DSS ®
satellite receiver.
The VCR channel should be set to the
output channel of the DSS
® satellite
receiver.
→
Go to step 8.
7 Select “BRAND TYPE” using STOP , and enter a brand code
of your DSS ® satellite receiver using number buttons . Refer
to the table on the next page.
Example: For a TOSHIBA DSS ® satellite receiver, identified by
number 99.
Make sure that the background of the above display has changed to
the satellite program on channel 200. If not, relocate the DSS
®
satellite receiver on the VCR so that it can receive the infrared signal.
8
Press PROG. to exit.
Notes
• If your satellite channel does not change to 200 in step
7 , the DSS ® satetllite
receiver will not be able to change channels in the timer recording. In this
case, set “CONTROL” to “OFF” in step
6 .
• The VCR Plus+ C 3 ® system recording is not available on satellite channels.
• The DSS ® satellite receiver control is not compatible with the cable box
control.
PROG
USE
OUT UT CH
P
E D: n
SET UP PRESET PROGRAM
C . BOX S S D
H C 3
9 9
O
n
. O n
n O FF O CO n T O R L
BRA n T D YPE
PROG
USE
OUT UT CH
P
E D: n
SET UP PRESET PROGRAM
C . BOX S S D
H C 3
1
O n
. O
n
n O FF O CO n T O R L
BRA n T D YPE
PROG
USE
OUT UT CH
P
E D: n
SET UP PRESET PROGRAM
C . BOX S S D
H C 3
O
n
n O FF O CO n T O R L
(Continued)