TiVo Ooma Hub - Manual (Page 40)

installing the ooma scout
With your ooma Hub device installed, all that’s left to do is connect each of your other phones to an ooma
Scout™ device. Each additional phone on the same phone line (or that will share the same phone number) as
the ooma Hub must be connected to an ooma Scout.
Your initial setup will look like:
To connect a phone to an ooma Scout:
1
If you have DSL, trace the phone cable to the wall. Unplug and remove any existing DSL filters or
splitters. Note: Some DSL filters and splitters are mounted flat on the wall jack.
2
Unplug the phone cable from your phone and plug it into the port labeled WALL on the ooma Scout.
3
Use a phone cable to plug your phone into the port labeled PHONE on the ooma Scout (a short phone
cable is provided).
4
Plug one end of the AC adaptor into the port labeled POWER on the ooma Scout and the other end into
a power outlet.
Now your setup should look like this:
After 30 seconds, the clear ooma Tab at the top left corner should turn blue. Pick up the phone connected to
the ooma Scout and you should hear the signature ooma dialtone.
WALL PHONE
Phone Jack Power
Phone Jack Phone Jack
DSL Filter