beautypg.com

Important recycling information, Power source – Toshiba MD24FP1 User Manual

Page 5

background image

5

Introduction

EXAMPLE OF ANTENNA GROUNDING AS PER THE

NATIONAL ELECTRICAL CODE

ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)

ANTENNA LEAD
IN WIRE

GROUNDING CONDUCTORS
(NEC SECTION 810-21)

GROUND CLAMPS

POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)

GROUND

CLAMP

ELECTRIC SERVICE

EQUIPMENT

27. LASER BEAM

Do not look into the opening of the disc tray or ventilation opening of the product to see the source of the
laser beam. It may cause sight damage.

28. DISC

Do not use a cracked, deformed, or repaired disc. These discs are easily broken and may cause serious
personal injury and product malfunction.

29. NOTE TO CABLE TV SYSTEM INSTALLER

This reminder is provided to call the Cable TV system installer’s attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be con-
nected to the grounding system of the building, as close to the point of cable entry as practical.

NEC-NATIONAL ELECTRICAL CODE

S2898A

IMPORTANT RECYCLING INFORMATION

This product uses both Cathode Ray Tube (CRT) and other components that contain lead. In

your community there might be regulations that require you to dispose these materials

properly under environmental considerations. Please contact your local authorities, or the

Electronic Industries Alliance (http://www.eiae.org) for disposal or recycling information.

TO USE AC POWER SOURCE
Use the AC polarized line cord provided for operation on AC. Insert the AC cord plug
into a standard 120V 60Hz polarized AC outlet.

Notes:
• Never connect the AC line cord plug to other than the specified voltage (120V

60Hz). Use the attached power cord only.

• If the polarized AC cord does not fit into a non-polarized AC outlet, do not attempt to

file or cut the blade. It is the user’s responsibility to have an electrician replace the
obsolete outlet.

• If you cause a static discharge when touching the unit and the unit fails to function,

simply unplug the unit from the AC outlet and plug it back in. The unit should return
to normal operation.

• If the AC cord plug is plugged in for the first time, wait for approx. 5 seconds before

pressing the POWER button.

Polarized AC Cord Plug
(One blade is wider than the other.)

AC Outlet

Wider Hole
and Blade

Power source

5M40101A [E] (P02-05)

20/4/04, 16:38

5