7register/de-register a handset – Topcom BUTLER 3300/Twin User Manual
Page 12

12
Topcom Butler 3300/Twin/Triple/Quattro
Topcom Butler 3300/Twin/Triple/Quattro
•
After 5 seconds, the telephone number will be shown. You can skip the date/time by
pressing the
button.
•
Use the left scroll key
to scroll to the previous call. Use the
button to show the
next call.
•
You can leave the Call list by pressing the button.
* Only when the network sends the time/date together with the telephone number!!! On
some networks with caller ID, time and date will not be displayed
6.3
Calling a number from the Call list
•
Scroll through the Call list until the desired number is shown on the display.
•
Press the Line button
. The number will be dialled automatically.
6.4
Erasing a number from the Call list
•
Scroll through the Call list until the desired number is shown on the display.
•
Press and hold the Mute button for 3 sec. to erase the number.
6.5
Store a number from the call log into the memory
•
Scroll through the Call list until the desired number is shown on the display.
•
Press and hold the Memory button
for 3 sec.
•
Enter the memory location (0-9) where you want to store the number
•
Enter the Memory button again to confirm and to go back to standby
7
Register/de-register a handset
7.1
Register to a Topcom B3300 base
You can subscribe 4 handsets to one base unit. By default, each handset is subscribed as
handset 1 on the base unit upon delivery (base unit 1).
!!! You only need to subscribe the handset if:
•
The handset subscription has been removed from the base unit (e.g. for reinitialisation)
•
You want to subscribe a different handset to this base unit.
The below procedure is only applicable to a Topcom Butler 33xx handset and base unit!!
Keep the Paging key on the base unit pressed for 10 seconds until the Line/Charge indicator
on the base unit begins to blink rapidly. The Line/Charge indicator will blink rapidly for one
minute. During this minute, the base unit is in register mode and you must do the following
to subscribe the handset:
•
Press and hold the
key for 3 sec, then press and hold the * key for 3 sec.
•
The following will appear on the display: