Technika 32-2010 User Manual
Page 19
English - 18 -
Select your
Country, Language and Text language
by using “ ” or “ ” and “ ” or “ ” buttons. Press
“
OK” or RED button to continue. To cancel, press
BLUE button. The following menu will be displayed
during the automatic tuning:
After APS is finalized, the programme table will appear
on the screen. In the programme table you will see
the programme numbers and names assigned to the
programmes.
Manual Channel Scan
In manual channel scan, the number of the multiplex is
entered manually and only that multiplex is searched
for the channels. For each valid channel number, signal
level and signal quality are shown on the screen.
In both manual and auto search any existing channel
in the database is not re-stored to avoid redundant
duplicates of that channel.
Clear Service List (*)
(*) This setting is visible only when the Country option
is set to Denmark, Sweden, Norway or Finland.
Use this setting to clear channels stored. Press “ ” or “
” button to select Clear Service List and then press OK.
The following On Screen Display (OSD) message will be
displayed on the screen:
Press OK to cancel. Select Yes by pressing “ ” or “ ”
button and press OK to delete all of the channels.
First Time Installation
The user can use this item to load default settings,
which were loaded to the receiver at the factory.
To install factory settings, highlight “First Time
Installation” menu item and press “
OK” button,
then you will be asked whether or not to delete the
settings. Selecting “Yes” by pressing “
OK” button
while the “Yes” is highlighted will delete the existing
channel table.
Then you will be asked to confirm for deleting all
channels and settings:
By selecting Yes and pressing the “
OK” button, the
existing channel table will be deleted. After factory
settings are loaded, “First Time Installation” menu
will be displayed.
The menu which is displayed for language selection
appears on the screen at first. By using “ ” or “ ”
buttons, select the desired language option, and press
OK button to activate.
After then, “First time installation” On Screen Display
(OSD) will appear on the screen. By pressing “ ” or
“ ” buttons, select the
Country you want to set and
press “
OK” button (* only for EU countries).
Press the “
OK” button to start installation. After search
is completed for digital channels, a message asking
whether to search for analogue channels appears
on the screen.This process is same as described in
Automatic Search section..