Toshiba B-EV4T SERIES - Manual (Page 19)

2. PRINTER SETUP ENGLISH VERSION EO1-33087
2.7 Loading the Media
E2- 8
2.7 Loading the Media
(Cont.)
2. Slide the Media Holder Lock Switch to the Unlock (▲) side to
release the Media Holders.
3.
Open the Media Holders.
4.
Place a media roll between the Media Holders so that the media is fed
with the print side facing up. Fit the projection of the Media Holders
into the core. Make sure that the projection of the both Media Holders
is engaged with the core firmly.
5.
Turn the Media Guide Adjustment Dial in the arrow indicating
direction to move the Media Guides outward.
Media Holder
Media Holder
NOTE: Media path
Platen
Feed Gap Sensor
Black mark sensor
Media Holder
Media
NOTES:
1. Refer to the Supply Path Label
attached inside of the Top
Cover.
2. Make sure that the print side
faces up.
3. Cut the leading edge of the
media straight with scissors.
Media Guide
Adjustment Dial
NOTE:
Do not forcibly move the Media
Guides by hand, as doing so may
break the Media Guides.
Media Holder
Lock Switch
Media Holder