Butler 1250 – Topcom BUTLER 1250 User Manual
Page 95
95
Notes :
•
Before you can select a base unit, the base unit must be subscribed to the handset first.
•
If ‘NOT SUB’ appears on the display, this means the selected base unit does not exist or the handset
has not been subscribed.
4.28 Barring outgoing calls
You can program the handsets to bar calls to certain telephone numbers so that for instance ‘00’
international numbers cannot be called. Up to 5 numbers (of max. 5 digits) can be barred.
To do this, do the following:
• Press the Programming key
.
• Press the Up or Down key
repeatedly until ‘SETTING’ appears on the display.
• Press the Programming key
.
• Press the Up or Down key
repeatedly until ‘BARRING’ appears on the display.
• Press the Programming key
.
• ‘PIN’ appears on the display.
• Enter your PIN code
• Press the Programming key
.
• ‘BAR NUM ’ appears on the display. You are in memory “1. _ _ _ _ _”.
• Press the Up or Down key
to select one of the 5 memories.
• Enter the number (max. 5 digits) to be barred, e.g. 01486.
• Press the Programming key
.
• ‘HS _ _ _ _ _’ (= number on the handset (1-5)) ‘01486’ (= the barred numbers) appear on
the display.
• Enter the numbers of the handsets from which the barred numbers cannot be called.
• e.g. Press the number key 2, 3 and 5. On the display, this will appear: HS _2 3_5 01486
These handsets can no longer dial numbers beginning with ‘01486’.
• Press the Programming key
to confirm your selection.
Repeat the same procedure described above if you would like to bar other numbers (max. 5)!
4.29 Default settings (reset) of the parameters
You can reset the standard (default) settings in the telephone so that they are the same they
were when you bought the telephone. You need the PIN code to do this.
The default settings are:
Answering machine:
- Keypad:
not locked
- Answering machine:
on
- Key clicks:
active
- Standard message:
OGM1
- Speaker volume:
level 3
- Number of rings:
3
- Ringer melody:
1
- Remote control code:
321
- Ringer volume :
5
- Selection base unit:
automatic
To restore the default settings, do the following:
• Press the Programming key
.
• Press the Up or Down key
repeatedly until ‘SETTING’ appears on the display.
• Press the Programming key
.
• Press the Up or Down key
repeatedly until ‘RESET’ appears on the display.
Butler 1250
B1250_NL_F_D_GB 25/3/02 3:09 pm Pagina 95