Topcom COCOON 50 User Manual
Page 29
8.6. RECEIVER VOLUME CONTROL
When you do not hear your caller loud enough, you can toggle the speaker
volume from high to low or from low to high by using the speaker volume
switch
on the handset.
8.7. SETTING THE RING VOLUME
8.7.1. RING VOLUME OF HANDSET
• Press the set button
• Press <5>.
• The LCD display will show the current setting of the ring tone on/off (LCD
version only)
• Press <1> for ring tone ON, <2> for ring tone OFF
• The LCD display will show the change (LCD version only).
• Press the set button
to confirm entry.
8.7.2. RING VOLUME OF BASE UNIT
The ringer volume of the base station can be set by means of a ringer volume
switch on the left side of the base station. This switch allows you to turn off the
ringer volume completely (position I) or to set the volume (position II= silent,
position III= loud).
8.8. MUTE FUNCTION
If you wish to talk to a third person without your correspondent hearing this
conversation, you can temporarily turn off the microphone. Simply press the
mute button
. For the display version the mute symbol will appear, and on
the LED version the mute
/low battery
LED will light and the radio
connection LED will flash. When you want to continue the telephone
conversation, press the mute button
again.
8.9. HANG-UP BUTTON
When you have made a mistake while dialling a telephone number, you can
press the hang-up button
and dial the number again. By pressing the hang-
up button
the line will be broken for about 2 seconds. By using the hang-
up button
, it is possible to make several phone calls after each other
without disconnecting the radiolink.
8.10. REDIAL
When you have dialled a telephone number but did not receive an answer or the
line was busy, you can call this number again afterwards. The last number
dialed is saved. When you wish to dial the number again, first press the line
button
and then, after hearing the dialling tone, press the redial button
(for the display version, the last number dialed appears on the display). The
telephone number is now automatically redialed.
If you wish to redial the number immediately without breaking the radio
connection with the base station, first press the hang-up button and then the
redial button
8.11 CALL TRANSFER (FLASH) R
With the flash button R - also called flash, recall or R button - you can transfer a
line to another telephone on your telephone exchange. The R button has a
flash function, this means that a short line interruption of 100 ms is being
generated. To set the interruption time see 8.16.
PROGRAMMING.
Consult the operating guide of your telephone exchange for a correct use of this
function.
This button is sometimes also used for special services offered on your public
telephone line (f.i. call waiting function).
8
9
50
50