Telular 900 - Manual (Page 7)

Phonecell ® SX6P GSM 1 User Manual
SX6P SETUP
SIM Card Installation
The SX6P requires a Subscriber Identification Module (SIM) for normal operation. The service
provider supplies the SIM card, which carries the account information needed to operate the
SX6P. The SIM compartment is on the back of the SX6P.
NOTE: If you don’t have a SIM card, contact your network service provider.
1. Make sure the unit is off and the power supply disconnected before removing or installing a
SIM Card.
2. Remove the SIM compartment cover by removing the screw.
3. Open the SIM compartment holder.
4. Line up the SIM card with the arrow on the SIM card holder - see Figure 1.
5. Gently insert the SIM card in the slot of the SIM card holder.
6. Close the SIM card holder.
NOTE: Do not force the SIM card holder shut. Make sure the SIM card is aligned properly
with the directional arrow on the holder.
7. Reattach the SIM compartment cover with the screw.
Install Batteries (optional)
1. Remove the battery access door screw located on the bottom of the unit - see Figure 2.
2. Press the battery access door tabs and remove the battery access door.
3. Install the Telular 3.6V rechargeable battery pack into the battery pack area.
4. Reinstall the battery access door using the screw - see Figure 3.
SIM Compartment Cover
SIM Card
Holder SIM Card
Cover Screw
Figure 2 – Battery access door.
Battery Access
Door Screw
Battery Access Door Tabs
Battery Access Door
Battery Pack Area
Figure 3 - Battery installation.
Figure 1 - SIM card installation.
WARNING!
Do not use batteries other than the included Telular battery pack with the SX6P.
Using any other batteries may result in fire and/or other damage to the unit. !