Telular 900 - Manual (Page 35)

CONFORMANCE STATEMENTS
The SX6P 850/1900 Mhz models are in conformance with all applicable FCC requirements.
FCC Part 15 Class B Compliance
This Phonecell ® SX6P model has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. Changes or modifications not expressly
approved by Telular Corporation will void your authority to operate the equipment per FCC part
15 paragraph 15.21.These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment OFF and ON, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the antenna.
• Increase the separation between the equipment and the terminal.
• Connect the equipment into an outlet on a circuit different from that to which the terminal is
connected.
• Consult your Authorized Telular Distributor or an experienced radio/TV technician for help.
SAFETY INFORMATION
The Phonecell ® SX6P functions as both a radio transmitter and receiver. When it is ON, the
SX6P receives and sends out radio frequency (RF) energy. The SX6P GSM 900/1800 unit oper-
ates in the frequency ranges of 890 MHz to 960 MHz and 1710 MHz to 1880 MHz. The
SX6P 1900 unit operates in the frequency range of 1850 MHz to 1990 MHz. Both units employ
commonly used phase/frequency modulation techniques. When you use the SX6P, the cellular
system handling your call controls the power level at which the unit transmits.
Exposure to RF (Radio Frequency) Energy
In 1991, the Institute of Electrical and Electronics Engineers (IEEE), and in 1992, the American
National Standards Institute (ANSI), updated the 1982 ANSI Standard for safety levels with
respect to human exposure to RF energy. After reviewing the available body of research, more
than 120 scientists, engineers and physicians from universities, government health agencies and
industry developed this updated Standard. In March, 1993, the U.S. Federal Communications
Commission (FCC) proposed the adoption of this updated Standard.
The design of your Telular Phonecell ® SX6P complies with this updated Standard. Of course, if
you want to limit RF exposure even further than the updated ANSI Standard, you may choose to
control the duration of your calls and operate your phone in the most power-efficient manner.
Phonecell ® SX6P GSM 29 User Manual