Perreaux SM6/P - Manual (Page 31)

31
Other Connections
1 x IEC AC mains input receptacle
Mains Input Voltage
100V, 110V, 120V, 220V, 230V or 240V AC at 50Hz or 60Hz
(Set within the SM6 at time of manufacture)
Dimensions
Width .............................................................................................. 482mm (19.0”)
Height ................................................................................................. 88mm (3.5”)
Depth .............................................................................................. 315mm (12.4”)
(not including feet, terminals and handles)
Fuse Ratings
Mains input fuse
100 – 125V: ........................................................................ 2SB slow blow 0.5A
200 – 250V: ........................................................................ 2SB slow blow 0.5A
(user serviceable)
Internal DC rail fuses...................................................2 x 2AG normal blow 0.5A
(NOT user serviceable)
Weight
Net: ................................................................................................... 7.7kg (17.0lb)
Gross:.............................................................................................. 10.7kg (23.6lb)
Specifications
Explained
Rated Output....................................................................................................1.5V
RMS
The SM6 has been designed to drive any amplifier to it’s full potential. Even
with an input level from a source component with a low level output, the SM6
has enough gain to provide the amplifier with an optimum signal, utilising the
full dynamic range and signal to noise specifications of the amplifier.
Maximum Output............................................................................................3.0V
RMS
The maximum output level of the SM6 has been designed to provide substantial
headroom allowing greater dynamics without clipping, handling any musical
transients with finesse and ease.
Total Harmonic Distortion
(THD+N)
............................. <0.004%, 20Hz to 20kHz
Total Harmonic Distortion + Noise is the percentage of output signal which is
made up of frequencies added due to harmonics of the fundamental frequency
and noise. By using a truly balanced circuit topology throughout the SM6 and
maintaining Class A operation at all stages, Perreaux engineers have kept this
figure to a minimum.