Tannoy Arena Highline 500 - Manual (Page 9)

STAND MOUNT
How to stand mount
Attach the spike kits, or rubber feet, to the bottom of the stand then thread the cable
through the stand base and shaft.
Cut the speaker wire so that the (+) wire is slightly longer than the (-) wire.
Screw the (+) wire into the red terminal and screw (-) wire into black terminal.
Important Note: It is essential that the speakers are wired correctly at this stage.
The (-) wire should have a solid black line or similar marked along it.
Offer the speaker up to the stand and use the 2 lock washers and fixing screws
to fit the speaker to the stand. Choose two fixing points on rear of speaker which give
the best height for your requirements.
9