Tannoy Arena Highline 500 - Manual (Page 5)

SATELLITE
How to wall mount
WARNING:
It is your responsibility to ensure that the bracket to wall fixing screws or bolts and
the walls themselves are strong enough to support the weight of the speaker – refer to the speaker
weight specifications supplied in this manual. Particular care is needed when fixing to hollow or
cavity walls - ‘'stud’' walls. Use only professionally recommended fixing devices which will spread
the load of the brackets and fixing screws over an area of the wall surface when mounting to cavity
walls. Pay particular attention to the possibility of electrical cables and gas or water pipes which
may be present in the wall cavity or buried in the wall surface. Use a special cable or metal proximity
locator to locate these obstacles if in any doubt.
Before wall mounting the bracket, ensure sufficient clearance to hook the speaker
onto bracket (approx half speaker length above bracket).
Use a spirit level to ensure the bracket is fitted level.
Mount the wall bracket on the wall with a suitable fixing
(not supplied – see warning note above)
Ensuring cap is uppermost, using 8mm screws and washers provided, attach bracket
with pre-fitted cap to top two fixing points on speaker.
Attach bracket without pre-fitted cap to bottom two fixing points using 8mm screws and
washers provided.
5