Toshiba D-R400 - Manual (Page 41)

41 EN 41 EN
Disc
Management
Recording
Playback
Introduction
Connections
Basic Setup
Editing
Function Setup
Others
SETTINGS FOR AN EXTERNAL DEVICE
front of this unit
rear of this unit
IN OUT
Y
PR/CR
PB/CB
L
R
L
R
VIDEO IN VIDEO OUT
S-VIDEO AUDIO IN (L1) S-VIDEO AUDIO OUT
COAXIAL
HDMI OUT
COMPONENT VIDEO OUT DIGITAL AUDIO OUTPUT PCM / BITSTREAM
UT 1080p
REC PLAY STOP SKIP
1080i 720p 480p
DVD -RW/R +RW/R RECORDING I/ y OPEN/CLOSE ON/STANDBY
S-VIDEO VIDEO L R DV IN L2
IN OUT
Y
P R /C R
P B /C B
L
R
L
R
VIDEO
IN
VIDEO
OUT
S-VIDEO AUDIO IN
(L1) S-VIDEO AUDIO OUT COMPONENT
VIDEO OUT
AUDIO OUT DV-OUT
L R
VIDEO
OUT
S-VIDEO
OUT
AUDIO OUT
L R
VIDEO
OUT
S-VIDEO
OUT
to L1 IN
external device
(camcorder, VCR etc.)
S-video
cable
RCA
video
cable
S-video
cable
DV cable
(4-pin)
RCA
video
cable
RCA
audio
cable
RCA
audio
cable
to L2 & L3 IN
or
or
or
L2 L1 L3
or
Connection to an External Device
Supplied cables used in this connection are as follows:
• RCA audio cable (L/R) x 1
• RCA video cable x 1
Please purchase the rest of the necessary cables at your local store.
Note
• When connecting an external device of monaural output to this unit, use AUDIO L jack of L2 (Front).
If you use L2 or L1 connection, make sure to select the appropriate video input type by following the steps in
“SETTINGS FOR THE VIDEO INPUT” on page 19.
Connect the external device properly to either L2 (front) or L1 (rear) input jacks of this unit by using S-video or RCA
audio / video cables. If you are connecting a DVC (digital video camcorder), connect it to L3 (front) by using DV cable.