Quatech Bluetooth To Serial Converter SS-BLT-400 - Manual (Page 9)

8
Follow the parameter setup procedures to configure the converter (see the
following chapters).
Terminator
The purpose is for compensating signal attenuation in long distance
connection at RS-485/RS-422 I/O. If the switch 1 & 2 are set in “ON”
position, the signal compensation will be activated. To disable the function,
just to push switch 1 & 2 to opposite position.
Set Button
The purpose is for synchronizing between this Bluetooth To Serial
Converter and “BT RS232 Config Tool” software. After finishing the
parameter setup of “BT RS232 Config Tool” software, when you click the
icon of “Connect” in “BT RS232 Config Tool” software and then use any
point tip to push this button immediately on the left side of the device. You
will see the icon of “Connect” turn into “Disconnect” and the meaning is
successful to active the device.
Set Button