System specifications – QSC Audio WL2102-w User Manual
Page 11
11
System Specifications (subject to change without notice)
Configuration:
Three way, bi amp or tri amp
Frequency Response
1
:
55 - 18,000 Hz (+/- 3 dB)
Frequency Range:
48 - 20,000 Hz (-10 dB)
Sensitivity:
LF: 98 dB (1W @ 1m)
HF: 107.5 dB (1W @ 1m)
Nominal coverage:
Horizontal: 140 degrees
Vertical: Dependant on cumulative splay angle
Nominal Impedance:
LF: bi amp mode 8 Ohm, tri amp mode 16 Ohm.
HF: 16 Ohm
Transducers:
LF: Two 10 inch (254mm) long excursion, high power, 3 inch (76mm) voice coil, 16 Ohm, 400W each
2
HF: 3.0 inch (76mm) diaphragm, 1.4 inch (36mm) exit, 16 Ohm neodymium compression driver on
proprietary patent-pending waveguide, 80W
3
Recommended Amplifier Power:
HF: 300W
MF: 700W tri amp mode
LF: 700W tri amp mode
LF/MF: 1400W bi amp mode
Enclosure:
Type:
Bass reflex (ported), trapezoidal
Material:
WL2102: cored composite laminate
WL2102-w: birch plywood
Finish:
Black or white texture coat
Grille:
Powder-coated steel
Connectors:
Two Neutrik NL8 wired in parallel
Attachment points:
Self contained rigging configuration. Front receiver tubes contain captive articulated joints (knuckle) and
ball-lock pins on lanyards. Rear mounting block has integral mounting link and ball-lock pin on lanyard.
Weight:
WL2102: 70 lb (31.8 kg)
WL2102-w: 83 lb (37.7 kg)
Accessories
Array Frames:
Stacking Frame: For suspended or stacking applications on QSC’s 215SB or 215 PCM subwoofer.
Frame weight 33 lb (15.0 kg).
Fly Grid: For suspended or stacking applications. Frame weight 87 lb (39.5 kg).
Software
EASE Focus line array modeling software tool available; visit www.qscaudio.com or contact QSC’s Technical
Services for DSP files for both QSControl.net and Signal Manager
Ball-lock Pins
WL2102:
Nylon Lanyard 5/16 inch dia. x 0.75 inch long, t-handle: p-n SR-000052-00 (Rear Link and Front Tube Pin)
WL2102-w:
7 inch Stainless Steel Lanyard 5/16 inch dia. x 0.75 inch long, t-handle: p-n HW-000106-00 (Rear Link Pin)
5.5 inch Stainless Steel Lanyard 5/16 inch dia. x 0.75 inch long, t-handle: p-n HW-000126-00 (Front Tube Pin)
Array Frames:
Nylon Lanyard- 5/16 inch dia. x 1.25 inch long, t-handle: p-n SR-000126-00 (Array Frame Pin)
NOTES-
1- with recommended DSP settings
2- 2 hours, AES 1984-2 method, 80 - 800 Hz
3- 2 hours, AES1984-2 method, 1,000 - 10,000 Hz