Orion 102mm EQ - Manual (Page 12)

12
SATURN The ringed planet is a breathtaking sight when it is
well positioned. The tilt angle of the rings varies over a period
of many years; sometimes they are seen edge-on, while at
other times they are broadside and look like giant “ears” on
each side of Saturn’s disk. A steady atmosphere (good see-
ing) is necessary for a good view. You will probably see a
bright “star” close by, which is Saturn’s brightest moon, Titan.
VENUS At its brightest, Venus is the most luminous object in
the sky, excluding the Sun and the Moon. It is so bright that
sometimes it is visible to the naked eye during full daylight!
Ironically, Venus appears as a thin crescent, not a full disk,
when at its peak brightness. Because it is so close to the Sun,
it never wanders too far from the morning or evening horizon.
No surface markings can be seen on Venus, which is always
shrouded in dense clouds.
MARS The Red Planet makes its closest approach to Earth
every two years. During close approaches you’ll see a red
disk, and may be able to see the polar ice cap. To see surface
detail on Mars, you will need a high-power eyepiece and very
steady air!
D. The Stars
Stars will appear like twinkling points of light. Even powerful
telescopes cannot magnify stars to appear as more than a
point of light.You can, however, enjoy the different colors of the
stars and locate many pretty double and multiple stars. The
famous “Double-Double” in the constellation Lyra and the gor-
geous two-color double star Albireo in Cygnus are favorites.
Defocusing a star slightly can help bring out its color.
E. Deep-Sky Objects
Under dark skies, you can observe a wealth of fascinating
deep-sky objects, including gaseous nebulas, open and glob-
ular star clusters, and a variety of different types of galaxies.
Most deep-sky objects are very faint, so it is important that
you find an observing site well away from light pollution. Take
plenty of time to let your eyes adjust to the darkness. Do not
expect these subjects to appear like the photographs you see
in books and magazines; most will look like dim gray
smudges. Our eyes are not sensitive enough to see color in
deep-sky objects except in a few of the brightest ones. But as
you become more experienced and your observing skills get
sharper, you will be able to ferret out more and more subtle
details and structure.
How to Find Deep-Sky Objects: Star Hopping
Star hopping, as it is called by astronomers, is perhaps the
simplest way to hunt down deep-sky objects to view in the
night sky. It entails first pointing the telescope at a bright star
close to the object you wish to observe, and then progressing
to other stars closer and closer to the object until it is in the
field of view of the eyepiece. It is a very intuitive technique that
has been employed for hundreds of years by professional and
amateur astronomers alike. Keep in mind, as with any new
task, that star hopping may seem challenging at first, but will
become easier over time and with practice.
To star hop, only a minimal amount of additional equipment is
necessary. A star chart or atlas that shows stars to at least mag-
nitude 5 is required. Select one that shows the positions of many
deep-sky objects, so you will have a lot of options to choose
from. If you do not know the positions of the constellations in the
night sky, you will need a planisphere to identify them.
Figure 9: Star hopping is a good way to locate hard-to-
find objects. Refer to a star chart to map a route to the
object that uses bright stars as guideposts. Center the
first star you’ve chosen in the finder scope and
telescope eyepiece (1). Now move the scope carefully in
the direction of the next bright star (2), until it is
centered. Repeat (3 and 4). The last hop (5) should place
the desired object in the eyepiece.
Start by choosing bright objects to view. The brightness of an
object is measured by its visual magnitude; the brighter an
object, the lower its magnitude. Choose an object with a visu-
al magnitude of 9 or lower. Many beginners start with the
Messier objects, first catalogued about 200 years ago by the
French astronomer Charles Messier, which represent some
of the best and brightest deep-sky objects.
Determine in which constellation the object lies. Now, find the
constellation in the sky. If you do not recognize the constella-
tions on sight, consult a planisphere. The planisphere gives
an all-sky view and shows which constellations are visible on
a given night at a given time.
Now, look at your star chart and find the brightest star in the
constellation that is near the object you are trying to find.
Using the finder scope, point the telescope at this star and
center it on the crosshairs. Next, look again at the star chart
and find another suitably bright star near the bright star cur-
rently centered in the finder. Keep in mind that the field of view
of the finder scope is about 6°, so you should choose another
star that is no more that 6° from the first star, if possible. Move
the telescope slightly, until the telescope is centered on the
new star.