One Stop Gardens 96415 - Manual (Page 4)

SKU 96415 For technical questions, please call 1-800-444-3353. Page 4
Place the Mosquito Killer on top of the Extension Poles (2) and pointed Ground 3.
Stake (3).
uSing the moSquito killer on a table
Always wear gloves when handling the Mosquito Killer. 1.
Place the Table Stand (7) on the bottom of the Mosquito Killer. It can then be placed 2.
on a table, or any flat, stable platform.
replacing the batterieS
Wear ANSI-approved safety Goggles and gloves when replacing Batteries. 1.
The Rechargeable Batteries (8) need to be replaced when the LED Light is flicker- 2.
ing, or only operates for a short amount of time. NOTE: Under normal conditions,
the Batteries (8) have to be replaced annually.
Remove the Mosquito Killer from the Extension Poles (2), or the Table (7) Stand 3.
and turn it over.
Remove all four Screws on the underside of the Solar Panel (1). 4. do not touch the
metal net (6). this mosquito killer can possibly shock even with batteries
(8) removed.
Open the Battery Compartment Cover (4) and remove the old Batteries (8). 5. dispose
of the batteries according to local regulations. never incinerate batteries.
Replace the old Batteries with two new AA rechargeable-type Batteries according 6.
to the proper polarity.
Replace the Battery Compartment Cover (4) and replace the four Screws into the 7.
bottom of the Solar Panel (1).
operation
Place on Extension Poles (2), or Table Stand (7), preferably in direct sunlight to al- 1.
low most favorable exposure to Solar Panel (7).
When you are ready to use, turn on Mosquito Killer using the ON/OFF Switch (5) 2.
located on the underside of the Solar Panel (1).
When finished using, turn off the Mosquito Killer with the ON/OFF Switch (5). 3.
note: If your yard has a fish pond, or water fall with small pond, place the Mosquito Killer
in close proximity but not close enough to be in danger of falling or getting knocked
into the water. It can be an effective mosquito control tool.