One Stop Gardens 96415 - Manual (Page 3)

SKU 96415 For technical questions, please call 1-800-444-3353. Page 3
do not touch the metal net (6). 8. The Metal Net (6) emits a small electric shock
which may be harmful and could possible damage the product.
keep the Solar panel (1) clean. 9. Wipe it periodically with a clean, slightly dampened
soft cloth and dry thoroughly when finished.
maintain labels and nameplates on the mosquito killer. 10. These carry important
information. If unreadable or missing, contact Harbor Freight Tools for a replace-
ment.
do not operate the mosquito killer near draperies or curtains. 11. These flam-
mable materials may catch fire.
do not clean with metal scouring pads. 12. Metal pieces can break off the pads and
touch electrical parts resulting in a risk of shock.
do not store anything other than the manufacturer’s recommended acces- 13.
sories with this unit when not in use.
keep bystanders and children at a distance while operating the appliance. 14.
caution: do not immerSe in water. 15.
the warnings, precautions, and instructions discussed in this instruction 16.
manual cannot cover all possible conditions and situations that may occur.
it must be understood by the operator that common sense and caution are
factors which cannot be built into this product, but must be supplied by the
operator.
SaVe theSe inStructionS.
unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.
aSSembly
note: For additional information regarding the parts listed in the following pages, refer to
the assembly diagram at the end of this manual.
uSing the moSquito killer on top oF ground Stake
Always wear gloves when handling the Mosquito Killer. 1.
Assemble the Extension Poles (2) by pushing them together. Push the Ground 2.
Stake (3) into the bottom Pole section.