Orion Car Audio XTR15001 - Manual (Page 11)

© 2009 Directed Electronics. All rights reserved. 10
AMPLIFIeR WIRInG
Power Connections for the XTR5001, XTR10001
and XTR15001
Power connections accept up to 4 AWG wire . •
4 AWG power and ground wire recommended for optimal per- •
formance .
Connect 12V+ to the battery through fuse holder . this connec-
•
tion provides +12V main power to the amplifier .
Power wire must be fused no more than 12” from battery .
•
Ground amplifier to a good chassis ground as close as possible to •
the amplifier .
Connect ReM terminal to remote turn-on lead from source unit .
•
this connection provides +12V power to turn-on the amplifier .
Add extra ground wire between the negative terminal of the
•
battery and the chassis .
NOTE: the addition of a ground wire from the battery to the chassis
of the vehicle improves the ability of the battery to supply power to
the amplifier . this is recommended because the current delivery of the
factory electrical system was designed only to accommodate electron-
ics supplied by the auto manufacturer .
Speaker Connections
the orion XtR5001, XtR10001, and XtR15001 amplifiers offer two
positive and two negative output terminals for ease of connecting the
speakers to the amplifier . since these are mono amplifiers, the speaker
connectors are paralleled internally . each amplifier is stable to 1
Ω . see
following diagrams .
Figure 9
Figura 9
Abbildung 9
L CH
+ _ +
_
R CH
L CH
+ _ + _
R CH
L CH
+ _ + _
R CH
COPY MASTER
GAIN
OUT
COPY MASTER
GAIN
0°
OUT
PHASE
COPY MASTER
GAIN
180°
OUT
PHASE
Master Amplifier Slave Amplifier