Agp slot – Olicom 2 User Manual

Page 15

SY-P4I865PE Lite DRAGON 2 Quick Start Guide

Har

Install

atio

This motherboard only support 1.5V AGP card (4X/8X card). If 3.3V AGP card is
used, the system will not boot-up and the AGPDET LED will lit.

CMOS Clear (JP5)

In some cases the CMOS memory may contain wrong data, follow the steps below to
clear the CMOS memory.

Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5. This
jumper can be easily identified by its white colored cap.

Then put the jumper back to 1-2 to allow writing of new data into the CMOS memory.

CMOS Clearing

Clear CMOS Data

Retain CMOS Data

JP5 Setting

Short pin 2-3 for

at least 5 seconds to

clear the CMOS

Short pin 1-2 to

retain new

settings

Note: You must unplug the power cable from the ATX power supply when
performing the CMOS Clear operation.

1 2 3

AGP Slot

If use 3.3V AGP c a rd,the system will no t p ower on a nd the AGPDET LED will lit.

(1.5V only)

(When AGPDET LED lit, it m eans 3.3V AGP c ard is used.)