OPPO Digital DV-970HD - Manual (Page 15)

S E T T I N G U P T H E P L A Y E R : A D V A N C E D
14
7. Channel Trim: To set the volume of each individual channel.
• Press the LEFT/RIGHT ARROW buttons to select the channel to be adjusted.
• Press the UP/DOWN ARROW buttons to raise or lower the volume of the selected channel in
0.5dB increments.
• Press the SELECT button to confirm the settings and return to the Speaker Setup Page.
Audio Setup Page
1. EQ Type (None/Rock/Pop/Live/Dance/Techno/Classic/Soft): This sets a corresponding
equalization pattern type to the current music track. Note: These EQ options are not available for
SACD, DTS or DVD-Audio tracks.
2. Sound Field (Off/Concert/Living/Room/Hall/Bathroom/Cave/Arena/Church): These allow
users to engage fun sound field effects that will alter the original audio presentation as it was
intended. Note: These EQ options are not available for SACD, DTS or DVD-Audio tracks.
3. SPDIF Output: This set the bit stream type of the digital audio output for use with Dolby Digital
and DTS-compatible receivers. The options are:
• Raw – Passes the encoded multi-channel digital audio unaltered. Choose this setting if your
receiver/amplifier is capable of decoding Dolby Digital and/or DTS.
• PCM – Forces down-mixed 2-channel digital audio output. Choose this setting if your
receiver/amplifier only supports stereo digital (PCM) audio.
4. LPCM Rate: To set the maximum Linear PCM output frequency. The options are:
• 48K – Supported by most equipment.
• 96K – Allows a higher sampling rate and frequency response. Ensure that the
receiver/amplifier can support it.
• 192K – Allows the highest sampling rate and frequency response. Ensure that the
receiver/amplifier can support it and that your dogs are safely away from the listening area.
Note: The LPCM rate is selectable only when HDMI Audio is turned off.